Additional information
Weight | 1 lbs |
---|---|
Dimensions | 12 × 12 × 4 in |
Mon: 9am-6pm CST
Tue: 9am-6pm CST
Wed: 9am-6pm CST
Thu: 9am-6pm CST
Fri: 9am-6pm CST
$46.00
2007-18 Jeep Wrangler JK JKU Alpine System Amp Interface – APH-CH01
With the ease of adding the AmpPro4 to a stock Alpine system, allowing getting an easy and clean signal from the stock messed up signal, Pac now has a harness that plugs into the factory amplifier plugs allowing a super easy way to by-pass the factory amplifier.
The factory amplifier is easy to get to and this makes it very easy to run your new amplifier to your door speakers without having to go through the hassle of running wires into your doors. The factory wiring is more than adequate to run more power through, unless you are running some very high power levels.
If you are not using the AmpPro but are using a more traditional signal converter or summer, like some of the products from AudioControl and Wavtech, then you can use this harness to get your signal straight. But if you are using this to get your signal after the amplifier, you will most likely need to use load resistors.
To make the whole system a plug-n-play setup, you can use the speaker harnesses to install your speakers without having to cut a single wire. Dash and Door.
Weight | 1 lbs |
---|---|
Dimensions | 12 × 12 × 4 in |