2015-20 Dodge Charger Amplifier-ready T-Harness with Load Resistors


2015-20 Dodge Charger Amplifier-ready T-Harness with Load Resistors

I have been selling and installing audio equipment for over 15 years and one of my rules for installing is to do as much of the prep outside of the vehicle. The less time in the vehicle, the less of a risk you have of damaging something and it generally makes it faster since working at a bench is better than an awkward position in the vehicle. This is one of the main reasons we wanted these T-harnesses for our Dodge Charger customers.

This is a Dodge Charger Radio T-Harness plug-n-play T-harness for behind the radio of the 2015-up Chargers. Other than installation simplicity, it also keeps you from cutting up the wiring behind your brand new truck.

If you are installing a 4-channel or 5-channel amplifier, or a multi-channel processor, then this is what you need. If the radio doesn’t see a speaker, or a load, then it will turn off the output of that channel. Meaning, you can do the best and prettiest install, but if the radio doesn’t see a “speaker”, then there won’t be any sound. This harness comes with the load resistors pre-installed on the harness, so your signal will be taken care of. We also add a foot of speaker wire to make adding your own wiring a bit easier.

There are many different ways to use this wiring harness. You can tap on and just add a line out converter to add a subwoofer, or add a couple to run your whole system. You can just take the signal from the radio itself and run it to a processor or line-driver closer to the amplifiers or feed it high level directly into the amp for your audio signal. Then, you can run your wires back from the amplifier to your speakers running the audio back through the factory speaker wiring. Lots of options and flexibility, it all depends on your systems needs.

The harness will come to you as a t-harness with all wires extended 17′ and taped in matching cloth factory tape. This comes with 17′ of speaker wire on the signal side of the harness, and on the speaker side and the wiring is long enough to reach the back wall to tie into your audio interface and your amplifier output. If you are wanting to do something else with it, feel free to let us know so we can make it a little more tailored to what you need.

We can also do the wiring modifications for you. If you want us to add line-out converters or additional wiring, we can make this harness a full plug-n-play setup. Those options will be coming, and we will be adding them in later.

There are a couple of things that can cause issues with the harness. If you do NOT have Alpine, there is a new difficulty with installing a 4-channel radio with the factory radio. Dodge is using Class D amplifiers now to power the speakers off of the radio and when the speaker wires are disconnected from the speaker, the radio quits putting out audio because it does not see the resistance of the speaker. So what you have to do is use a proper line-out converter that has the load resistors built into it, or add load resistors to the harness manually. It’s a hassle, but it works. If you would like, we can add them for you or we can sell and install the proper line-out converter for you.

If you have the Alpine system, there is a better solution. AP4-CH41

Dodge Gallery

Contact Us About Your Options (This is only if your order requires some advanced customization. If you need a customization fee, we’ll let you know).

Recommendations for amp to be mounted at passenger backwall: 17 feet for HD and 14 feet for 1500
  • Total

Lease for as low as $9.17/week. Learn More

Additional information

Weight 4 lbs
Dimensions 14 × 4 × 3 in